KÄRCHER ROBO 30 pipe boring machine for pipes, flat material and
profiles
With this machine, tubes, flat material or profiles can be cut very
quickly and accurately in a single pass.
can be drilled or milled at an angle or at an angle up to 50° in
such a way that filling rods or filling tubes up to 1" can be drilled
or milled
can be plugged through.
With the standard additional clamp for the jaw chuck, you can not only
cut pipes, but also
transport flat material or other profiles with the feed and at the
desired angle up to over
Make 50° single-sided holes or through holes.
The clamping jaws in the self-centering vice have a recess at the top
for flat material.
We are unrivalled when it comes to converting to another material!
The feed is positioned at 0.1 mm with the counter with absolute or
chain gauge.
With the ROBO 30, you don't need to set limit switches or cams for
pipe feed.
Elaborate alignment with all possible tools and rework is now part of
the
past.
Pipes can be drilled/milled from the 2nd side for through holes. To do
this, the pipe is connected to the
jaw chuck twisted by 180° and the unit was quickly moved to the other
side at the stop or onto the
swivelled to the desired angle. And in less than 10 seconds!
The machine has a pneumatic drill feed in the Z-axis with hydraulic
brake cylinder
which grants a defined lead time. The changeover point is easy by
means of a limit switch
manually adjustable and the feed and working speed is infinitely
adjustable via a valve.
Your benefits:
Huge time saver and very easy to use. This means that the demands
on the operator are low
Because almost no welding seams are required, there is no need for
expensive plastering.
Natural-based minimal cooling lubrication developed for stainless
steel, also for your saw.
Inexpensive HSS PM milling cutters can be used.
Self-centering clamping jaws for and flat material
Flow forms and thread forms ( with C8 / B8 ) in 1 clamping
You are K511148 welcome to test this machine with us and find out
that you can drill some angled holes.
in less than half the time and with much better quality.
Specifications:
KÄRCHER railing boring machine ROBO 30
Chuck for pipes adjustable radial with scale infinitely variable
fast/fine
Max. tilt angle left / right 53 degrees
Max milling diameter in INOX flat material ° 20 mm
Max. milling diameter in INOX - tube 43 mm
Flow forms in INOX pipe S = 2 mm M 5 – 6 – 8
Speed infinitely variable via frequency converter
Feed length of tube/profile via timing belt approx. 3000 mm
Motor power 2.2 kW
Electrical connection 230 V
Air connection 6 bar
Max. tube diameter approx. 78 mm
Max. dimensions flat steel St. and INOX 80 x 12 mm
Collet ER 32 max. clamping diameter 20 mm
Overall dimensions: L x W x H approx. cm 402 x 100 x 183
Weight approx. kg 540
Germany
