The FORNI INDUSTRIALI FIBEX COMBI 6GX-10.130-7110.2E.270 brazing
furnace was built by the Italian company Forni Industriali Heat
Treating Plants in 2007. The furnace is used for soldering steel
elements with solder paste at temperatures up to 1120 degrees Celsius.
At the entrance and exit of the furnace, two pairs of gas burners
(so-called safety pilots) are installed to prevent the escape of the
protective atmosphere outside the furnace. Electric heaters powered by
thyristor temperature regulators are responsible for the proper
temperature in the furnace. The belt furnace has a conveyor speed
adjustment in the range from 0 to 500 mm / min, and the working length
of the soldering zone is 7100 mm. The furnace for brazing steel
elements was modernized in 2021 - the thermal insulation and the
cooling module for sections 1 and 2 were replaced. The cost of the
modernization was 70,000 Euro.
Technical data of the FIBEX COMBI 6GX-10.130-7110.2E.270 belt
furnace
- maximum operating temperature in the soldering zone: 1120 degrees
C
- working length inside the soldering zone: 7100 mm
- length of the cooling M5351405 water jacket: 14,000 mm
- loading table length: 2000 mm
- length of the unloading table: 1700 mm
- natural gas supply with pressure: 20 - 400 mbar
- nitrogen supply at a pressure of 50-200 mbar
- cooling water supply pressure: 0.8-1 bar
- speed regulation of the conveyor belt in the range: 0-500 mm /
min
- heating power demand in the soldering zone: 270 kW
- power requirement for engines and control devices: 8 kW
- total length of the soldering machine: 28,000 mm
Poland
