ENGEL INSERT 60H/30 SHUTTLE injection moulding machine was
manufactured in 2016 in Austria. A specialised machine with a small
footprint, is used for, among others, the overmoulding of inserts and
the joining of various materials such as glass, metal and electronics.
Thanks to the electric control of the injection unit and the
‘pressure locking’ system for the injection cylinders, the
injection moulding machine guarantees high repeatability and excellent
quality of inserts.
The ENGEL INSERT 30 injection moulding machine allows you to set the
speed and clamping force to prevent damage to the mould. Once both
mould halves are closed and a high closing force is generated, the
injection unit pushes the nozzle against the injection sleeve of the
mould and produces an adjustable clamping force. At the end of the
cycle, a very powerful screw with a diameter of 18 mm injects the melt
under high pressure into the mould cavity. To prevent the molten
material from backing up into the screw coils, the screw is equipped
with a mechanical valve lock.
The machine operating with a maximum clamping force of 30 tonnes is
equipped with a large sliding table with workstations on the left and
right sides of the injection station, significantly facilitating mould
handling. The machine’s extensive equipment also includes a PIOVAN
S50 plastic feeder with integrated blower, an ENGEL flomo mould
temperature controller and a state-of-the-art ENGEL CC300 CNC control
with touchscreen. The vertical injection moulding machine has only
worked 348 hours.
Technical specifications of the ENGEL INSERT 60H/30 SHUTTLE plastic
injection moulding machine
- man-hours: 348 h
- maximum clamping force: 30 t (300 kN)
- injection volume: 25 cm3
- injection capacity: 66 cm3/s
- increased injection capacity: 49 cm3/s
- injection pressure: 1815 bar
- increased injection pressure: 2204 bar
- mould opening stroke: 308 mm
- screw diameter: 18 mm
- maximum screw speed: 450 rpm
- injection nozzle stroke: 530 mm
- injection nozzle clamping force: 28,3 kN
- nozzle bore: 3 mm
- nozzle radius: 35 mm
- ejector stroke: 105 mm
- ejector force: 20.1 kN
- pump drive power: 15 kW
- material hopper capacity: 3 l
- material feeding capacity: 50 kg/h
- oil thermostat tank capacity: 8 l
- oil thermostat operating M5351405 temperature range: 20-160 °C
- maximum drying capacity: approx. 25 kg/h
- maximum drying temperature: 140 °C
- power of plastic dryer: 2 kW
- cooling capacity: 6.6 kW
- fan capacity: 6100 m3/h
- INSERT 60H/30 SHUTTLE machine power supply: 3x 400 V; 50 Hz
Equipment of the injection moulding machine
- CNC control: ENGEL CC300
- plastic dryer: PIOVAN DS503+T30
- plastic feeder: PIOVAN S50
- mould temperature controller: ENGEL flomo
- material hopper: PIOVAN T3M
- 2-position hydraulic sliding table
- cooler: PIOVAN CH50
- oil thermostat: PIOVAN TO 112
- clamping platens with 125 mm diameter centering hole, type
EUROMAP
- oil filter station OM 1.0
- central ejector on both stations of the sliding table
- photocell for rapid mould installation/removal by the operator
- contact-free travel sensors
- magnetic air valve
- standard check valve R9b
- ring check valve
- mechanical mould closing protection
- ceramic heating elements
- USB interface
- Ethernet interface