For sale is a overhauled baler, with 100 tonnes pressing force, large
format 1100 x 1100 mm, 75 kW drive power and 10-fold cross
binding
Technical data baler:
Manufacturer
Bollegraaf
Typ HBC 110 K / 75 kW
Year of construction
2007
Press power main press 100 tons
Press power of pre-press
50 tons
Operating hours 22,605 hours
Feed channel 1,600 x
1,100 mm
Capacity per cycle time 3,15 m³
Theoretic cycle time
19 sec.
Bale size 1,100 x 1,100 mm
Driving motor 75
kW
Connected load 126 kW
Full load current 238 A
Tying
system 5-fold vertical, 5-fold horizontal, fully
automated
Throughput rate at a
bulk weight of 30 kg/cbm
approx.16 tons/h
bulk weight of 50 kg/cbm approx. 25
tons/h
bulk weight of 100 kg/cbm approx. 47 tons/h
Bale weight
up to 1400 kg, depends on material and bale lenght
Volume oil tank
approx. 1,300 l
SPS controller Telemecanique TSX
Micro
Operating panel Schneider MAGELIS Touch
Baler dimensions
built up with hopper 11,750 x 5,000 x 7,105 mm (l x w x
h)
Transport dimensions only baler 11.750 x 2.500 x 3.450 mm (l x
w x h)
Machine weight baler approx. 36
tons
Comments:
The press was partially overhauled and
serviced in our workshop and tested and stored after completion of the
work. The machine is available at short notice and can be inspected in
our warehouse by appointment.
The following overhaul work
was carried out:
Rust removal and partial painting of the
press.
Remaining hydraulic oil tank drained, oil filter and air
filter replaced.
New hydraulic oil topped up.
All hydraulic
hoses replaced.
Main hydraulic cylinder, two cylinders of the
prepress flap and the cylinder of the press channel dismantled,
disassembled, checked, cylinder tubes honed, all seal sets replaced
and a final pressure test carried out.
Disassembly of the prepress
flap with bearings and bearing blocks. 1st and 3rd circular arc segmet
cut out and a new one welded in again.
Both bearings of the shaft
of the prepress flap replaced.
Upper material deflector on the
frame of the prepress flap replaced.
Press ram dismantled, checked
and both front rollers replaced.
Material deflectors and O5151246
wear profiles on the sides and base of the press ram cut off and new
ones welded in.
Horizontal and vertical needle and tying unit
dismantled, disassembled, checked, plastic sliding plates, bearings of
the drill shafts and wire deflection rollers with bearings in the
needle heads replaced.
Both bronze slide rails on the left and
right in the frame cover to the press ram replaced.
Both wire
deflection units on the left and right, with bale retaining clamps,
completely renewed.
Wire insertion unit including hydraulic
cylinder under the needle feedthroughs completely renewed.
Wire
entry marks in the floor and side walls of the bale chamber welded
shut and smoothed.
General maintenance and service work carried
out in accordance with the manufacturer)s specifications.
Press
tested in manual and automatic mode, accepted and stored after
completion of overhaul work.
We accept no liability for the
technical specifications or any errors.
Netherlands
NL 
