Екструзійна лінія APV 125MP compounding line

техніка для переробки пластмас / екструдери

вимагати більше фотографій

Exapro S.A.S
[ профіль дилера ]

49400 Saumur
France

дилер техніки член з 2023

список машин (4980)

відправити запит

додати до списку

відправити запит

Номер позиції: 164837776	Кількість: 1	Дата: 18.09.2024
Рік випуску: 1990	Місцезнаходження: Хорватія / Гравця

Ціна:	142,000 EUR
Виробник:	APV
Модель:	125MP compounding line
Тип техніки:	Екструзійна лінія
Опис:	Екструзійна лінія APV 125MP compounding line вживана машина Extruder is missing electronics and it is not in running condition. Barrel 30D The barrel was opened for inspection of the liners and shafts, the hydraulics function correctly. Liner 1. Feed, 2.5D good condition Liner 2. Inter, 5.0D good condition Liner 3. Inter, 5.0D good condition Liner 4. Inter, 5.0D good condition Liner 5. Inter 5.0D good condition Liner 6. Inter 2.5D good condition Liner 7. XLT Discharge 5D good condition. Feed and return lines were removed and compressed air fed into circulation blocks. All blocks were found to have good flow. Pipework is in good condition with all solenoids present. All control thermocouples and melt thermocouples are in place but could not be tested due to condition of electrics. All the heaters are in place but could not be tested due to the condition of electrics. The barrel is in very good overall condition. Shafts All elements are in good condition with very little visible wear. Customer has numerous spare elements and 2 sets of new shafts Spares held by customer, Feed Screw 1D 1D 18 off Feed Screw 1.5D 1D 14 off Feed Screw 0.75D 1.5D 6 off Feed Screw D/4 1.5D 4 off Tight Helix Feed Screw 1D 5 off Feed Screw – XLT transition 1.5D 1D 5 off Orifice plugs D/4 4 off Paddles D/4 69 off XLT FS 117mm 3 off XLT FS 156.25mm 6 off XLTD FS 156.25mm 3 off End pins 2 off Set of shafts E4961673 2 off Gearbox The motor coupling and the shaft couplings were disconnected from the gearbox. No excessive backlash, end float or radial movement is present in the input or output shafts. Timing is ok. There are no visible oil leaks. Electrical panels The extruder electrics/electronics have been badly vandalized and as far as I can see very little can be salvaged and a new panel would be needed in order to run the extruder and feeders. The original panel controlled 8 feeders and all ancillary equipment and ran on Siemens S5 see below photos. seller offer No. resale P91004100
Seller-item-No.:	P91004100

Розповісти про цю машину на Facebook: