| tarif: |
RDF, MSW, kağıt, karton için balya açıcı hattı CROSS WRAP OY LTD., SIILINJäRVI, FINNLAN BO 4000
kullanılmış makine
Technical data of the bale opener line for RDF. MSW, paper,
cardboard:
Manufacturer Cross Wrap Oy Ltd, Siilinjärvi,
Finland
Type BO 4000
Year of manufacture 2015
Quantity of
opened bales 674 pieces
Operating time only 3 days, exclusively by
running in the entire line during new installation
Opening time
approx. 45 seconds per bale
Bale dimensions (W x H x L) 1100 x
1100 x 1400 - 1900 mm
Max. Bale weight 2,000 kg
Conveying
height of the system 1,400 mm
Max. Conveying width of the system
1,200 mm
Material to be opened RDF/MSW
Availability of the
line 98%
Noise level of the bale opener line 85 dB(A)
Total
connected load 37 kW
Rated current 125 A
Operating display
SIEMENS SIMATIC HMI Touch
Control SIEMENS S7
ET200S
Installation dimensions 8,463 x 2,890 x 3,960 mm (l x w x
h)
Scope of delivery:
Feed conveyor 3,500 x 1,200 x 1,400
mm
Feed conveyor to opener 1,500 x 1,200 x 1,400 mm
Bale
opener (gripper with knife)
Special equipment:
Oil
heating in hydraulic oil tank
Heating in control cabinet
Oil
cooler in Hydraulic unit
Explanation of the short period of
use:
The entire line of Cross Wrap bale openers type BO 4000 was
installed at a municipal waste incineration plant in 2015. The
background to the installation was that in the case of a malfunction
or maintenance of the incinerator, the municipal waste could continue
to be received, baled, wrapped and stored until the malfunction was
cleared. Then the bales should all be opened again and the waste fed
into the normal incineration process.
This worst-case
scenario never came to pass. The plant was set up, run in and then
never used in regular operation. Only during the commissioning and
running-in of the entire plant in 2015 were 674 bales opened on three
days. The plant is in very good condition and ready for operation
immediately. Due to reconstruction measures in the incineration plant,
the installation area of the bale opener was needed. As a result, the
entire line is for sale.
Short description of the wrapping
process:
The pressed bales are placed on the infeed conveyor belt
from the side or from behind by means of a forklift O41151246 truck.
For opening, the bales must run horizontally to the conveyor belt with
the wire or twine binding, otherwise the bales must be turned 90°
beforehand. The opening conveyor brings one bale at a time in front of
the cutting unit. The grippers hold the wires or twine strapping. The
front and rear rotating knives slit the bale lengthwise. Afterwards,
the gripper returns to the starting position. The opened bale is now
conveyed via the conveyor belt to the discharge chute and then falls
onto the following conveyor system.
Comments:
New price
of the completely plant 296.000,- ?. The documentation (operating
instructions, CE declaration, electrical/hydraulic circuit diagram) is
complete. The unit has been dismantled into freight-manageable units,
stored and is available for inspection and loading at short notice. We
do not accept any liability for the technical details or any
errors.
seller offer No. resale Cross_Wrap_bale_opener_line_BO4000
|