dimensions of saw-band: 3650x27x0,9 mm
speed: 15-100
m/min
vice: 335 mm
capacity 90 degrees: round: 300
mm
capacity 90 degrees: square: 260 mm
capacity 90 degrees:
flat: 330x260 mm
capacity 45 degrees: round: 260/200
mm
capacity 45 degrees: square: 250/180 mm
capacity 45
degrees: flat: 270x200/200x160 mm
capacity 60 degrees: round: 180
mm
capacity 60 degrees: square: 170 mm
capacity 60 degrees:
flat: 170x170 mm
total power requirement: 2,2 kW
weight: 1.105
kg
dimensions: 2700x2300x1800 mm
Fully automatic
electro-hydraulic band saw with multi-micro processors
and
additionally semi-automatic, semi-automatic-dynamic and
manual
Function.
- Automatic cycle (cuts from 0 ° to 60
° link). CNC machine with two
controlled axes that allow for the
same material thickness 1000
various editing programs, each with a
different cutting length and quantity, too
program.
-
Semi-automatic, semi-automatic-dynamic and manual cycle (cuts
from
45 ° right to 60 ° left)
- Semiautomatic dynamic system (manual
lowering of the saw band bow up to the
desired position and cycle
start via the push button.)
- Manual or semi-automatic-dynamic
cycle to cut directly without
Programming.
Some
features:
- New fieldbus communication system (Modbus
protocol)
- Display with 20 characters x 4 lines to display the
technical parameters such as:
- Saw blade speed - Number of
programmed and executed cuts
- saw blade thickness - feed length -
cutting time - ammeter - belt tension -
Display of (about 100)
diagnostic messages and warnings, everything in the
respective
user language.
- Display and entry of the alarm and error messages
with the possibility of
display incidents that have
occurred.
- automatic parameter setting via control, if a new
driver or
Inverter is mounted.
- Electronic inverter for
continuous regulation of the belt speed of 15
up to 100 m /
min.
- New hydraulic control unit of the latest generation, highly
efficient
and with low energy consumption.
- New material
supply of 600 mm with stepper motor and B5346911 ball
screw
mounted on opposite ball bearings.
- Hublauf the saw
blade directly from the control panel programmable, for
Adaptation
to the cutting material.
- Electronic band tension control.
-
Automatic monitoring of the cutting load by a direct on
the
Cylinder mounted servo valve.
- The coolant sump (equipped
with 2 electric pumps for lubrication and
Cooling of the saw
blade) is installed in the base.
- Swarf drawer (can be replaced
by a chip conveyor - see
Optional)
- Preparation for the
installation of the minimum lubrication set of the saw
blade
(Optional), in addition to conventional standard lubrication
with emulsion oil.
Chip removal brush.
- Machine is intended
for lifting truck transport.
- Bi-metal saw band for solid and
profile material.
The data for this ad was
created with ModulMWS - the software solution of LogoTech
oHG.
Германия
Günzburg
