Hot needle micro perforation machine, make LaserPin (IT), year 2020, -
Usable width for micro-perforation = 1400 mm, - Maximum speed = 250
meters/minute, - Diameter of holes = 0.3mm to 2.8mm, - Maximum
temperature = 400°C, - Heating power = 37 KW, - Touchscreen control
panel, The machine was bought in mid-2020 and only used for less than
100 hours, HOT MICROPERFORATORS = With the hot needle technique, the
hole is created by the melting of the material caused by heated
needles., The pin cylinders are mounted on a perforation roller. They
are heated to a temperature of 400°C by special lamps., This
technology creates homogeneous holes and was developed in the 80s., An
industrial standard control cabinet system with WiFi modem (purchased
separately and, configured) for wireless connection to any existing
inline production system., User-friendly and multilingual control
panel with additional buttons / controls for manual, Service.,
Intelligent web guiding system: For precise control F5350968 over,
Perforation position and precise film width position., - Already
synchronized with the machine., - Automatic and manual command
system., 14 steel / rubber drums and 4 pneumatic cylinders for precise
positioning of the film, In addition, a counter roller with a banana
rubber roller was purchased separately., Foil cutter with pneumatic
tension shaft for a more firm grip of the foil roll without damaging
the foil roll, Role.
Alemania
willich 
