Barwell MR400 Top Load Ram Extruder  ...

• more information

Barwell Cryogenic Deflashing and Deburring Machine Freeze Trim Chamber Model BFT10  ...

• more information

8" Cold Feed Rubber Extruder  ...

• more information

clamping force: 450 kN injection volume: 135 cm³ screw diameter: 35 mm platen size: 600 x 400 mm Condition: used, Specification: C-frame injection moulding machine for TPE - used clamping unit: - clamping force: 450 kN - heating platen size: 600 x 400 mm - sliding table: yes - Clamping direction: from below - Ejector / lifter: Up + Lo Injection unit: - Injection volume max.: 135 cm³ - Screw diameter: 35 mm - Connected load: 3x 400 V, 50 Hz - Weight approx.: 5,500 kg The data for this ad was created with ModulMWS - the software solution of LogoTech oHG.

Rubber buffers / silent blocs for concrete block machines Brands: SCHLOSSER, Hess, Masa, Omag, Rekers, Frima, Techmatic Web: contec-ek  ...

• more information

Nakata Zoki Kobe, Japan (Troester design) Duplex Extruder Unit Dual 150mm dia PIN Type Extruders, Year of manufacture: 1990, with Roller Feed, and duplex Die. L/D ratio 16:1 Number of Pins: 10 Rows x 8 Pieces, Spare Pins included. Screw Speed 45 r.p.m. Motors 185kw D.C. variable speed, 415 volt, 3ph, 50hz. Full Books and Drawings available. Thyristor Drives included. Starter and Control Panel for Lower Extruder only. Die usable Width 18\\, In good condition.

1 x Francis Shaw 45mm dia coldfeed rubber extruder, M/c no. 4513, Year: 1992, power roll feed, L/D ratio 15:1, hinged straight head with c\clamp, cored scred + jacketed barrel with built in temp control unit. Complete with control panel and in very good condition. Box of dies included.  ...

• more information

Used rubber extruder make Troester, type GSV 60/k-12-18D-m.S., Execution as desired, with or without vacuum Built in 1991, machine was in operation until the beginning of 2010 Feed roller Kpl. new drive with flat gear motor Screw speed max. 62 rpm. Engine power 22 kW Control with PLC and temperature control new on request Extruder similar to attached photos.

Used Troester rubber extruder type GSV 60/k-12-18 D with feed roll can be modified/overhauled according to customer\s specification, with or without vacuum, year of construction: 1991 machine was in operation until end of 2010. including feed roll, new drive with flat-gear motor screw speed: maximum 62 rpm motor power: 22 kW PLC control and TCU can be renewed, if requested.

Troester.200mm H/F strainer M/C Number 7175-71 L/D 6.5/1 Roller Feed 350mm. Hinged strainer head with hydraulic clamp. 125KW AC v/s motor. On single bedplate. With controls.  ...

• more information